Milling of Al 6060 Alloy with DLC Coated Cutting Tools
Mustafa Ay
Marmara University
Ayhan Etyemez
PDF

Keywords

Cutting
GRA
MQL
Taguchi
Al 6060

How to Cite

Ay, M., & Etyemez, A. (2019). Milling of Al 6060 Alloy with DLC Coated Cutting Tools. International Journal of Innovative Research and Reviews, 3(1), 25-29. Retrieved from http://www.injirr.com/article/view/29

Abstract

In this study the effects of rotation, feed rate and MQL cooling system flow on surface roughness and cutting forces in milling Al 6060 alloy with DLC coated cutting tools are investigated. Taguchi method was used in the test design. Thus, time and cost are saved in the tests. The results obtained from the tests were optimized and improved. Surface roughness and performance were improved with the Taguchi method. In this study, optimal workability of Al 6060 material with DLC coated end mill was tried to be determined with grey relational analysis and surface roughness and cutting force optimization was made. Optimum values were obtained when the revolution was 3500 rpm, the feed rate was 450 mm/min. and MQL rate was 30 l/h.

PDF
Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

The authors keep the copyrights of the published materials with them, but the authors are aggee to give an exclusive license to the publisher that transfers all publishing and commercial exploitation rights to the publisher. The puslisher then shares the content published in this journal under CC BY-NC-ND license.